10000W Motor Speed Controller AC 220V Voltage Regulator Dimmer Switch Speed Controller,with Switch

This item has new two-way power silicon controlled rectifier and the current can be up to 80A, which is a good solution to over-current of electric stove wire caused by low resistance during cooling.<p>It can adjust the output voltage on a scale of 0-100% (nonlinear) to power electric device.<p>Designed with and thick heat sink that would enhance heat dissipation.<p>This voltage regulator is adjusted with button which is much more stable than potentiometer.<p>Voltage regulator has wave voltage absorbing circuit and effective protects power silicon controlled rectifier, service life and more durable.<p><p>Color: silver + green<p>Material: PCB+Metal+ABS<p>It can be used as power supply for electrical devices of less than 10000W, enough for household appliances or for small factory.<p>Could be widely used as heat controller on electric stoves, , light dimmer on , speed controller on small motors, or temperature controller on electric soldering iron.<p>Specifications:<p>Voltage: AC 220V<p>Max Power: 10000W(instantaneous limit power for impedance load; for long time use, 5000w or lower is recommended)<p>Voltage Adjustment: 0-100% (nonlinear)<p>Controller Size: 95.7 x 56.7 x 53.8mm/3.76 x 2.23 x 2.11 inch<p>Panel Size: 75 x 60mm<p>Note:<p>1, AC input, AC output, output voltage is lower than(or to) input voltage; voltage can be adjusted only when connected to load; mainly used for resistive load.<p>2, It can not replace electric bicycles' battery charger, nor drive electric appliances which use switch power supply (such as 110V TV, speaker, refrigerator, air conditioner, rice cooker with a computer), and cannot drive induction cooker, energy saving lamp.<p><p>Package Contents:<p>1 x Controller<p>1 x 3 keys with switch panel<p>1 x Cable<p><p>Only the above package content, other products are not included.<p>Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.