5A Dc-Dc Mppt Solar Panel Solar Controller Module Regulator Controllers Constant Voltage Constant Current Charging

Product parameters: Module nature: non-isolated step-down module Size：6*3.1*2cm/2.36*1.22*0.79in Color: as shown Packing list: 1pcs Input voltage: 6-36V Output voltage: 1.25-32V continuously adjustable, Output lamp range: 0.01-5A (default lamp current is 0.3A) Operating temperature: -40~+85 degrees Operating frequency: 180KHz Conversion efficiency: up to 95% (efficiency is related to input and output voltage, current, and pressure difference) Short circuit protection: Yes Over-temperature protection: Yes Input reverse connection protection: No Output anti-reverse protection: No, when the output is connected to the battery, be sure to add an anti-reverse diode, otherwise the module will burn out! Charging indication: The red light is on when charging and the green light is on when fully charged. The detection method of the turning light is current. When using solar panels for power supply, the charging current is also very small during the solar hours, which is lower than the turning light current. The green light will also be on, but it is not fully charged at this time. Please pay attention to the difference. You can see the charging current more directly with a meter head. Wiring method: terminal block (welding wire output when equipped with a shell) IN is input, OUT is output Note: The current detection of the module is low-end detection. Please do not short-circuit the negative pole of the input and the negative pole of the output directly with a wire! Application range: 1. DIY a voltage-stabilized power supply with constant current function, no need to worry about short circuit during use, and can protect the load 2. Charge various batteries, set the charging voltage and charging current according to batteries of different voltages and capacities, with charging indication function,convenient to observe the charging status. 3. Use solar panels to charge various batteries, with MPPT function, which can increase the charging current by more than double. With constant current function, it can prevent battery overcharge and effectively protect the battery. 4. Drive high-power LED, which can be freely connected in series and parallel. If the module has no output voltage, please adjust the MPPT setting potentiometer clockwise to have voltage output. Note: 1.Please allow 1-3cm differs due to manual measurement. 2.Due to the different monitor and light effect, the actual color may be a slightly different from the picture color. The merchant warrants that their products comply with all applicable laws, and are offered only if they comply with Joom's policies and EU Product Safety and Compliance laws.