JST10 SH10 4pin cable with socket male head Dupont wire For STEMMA QT For QWIIC Both ends are equipped with JST-SH female 4-pin connectors. These are 1 mm spacing instead of 2 mm compared to the coarser JST-PH, but still have a good latch feel while being easy to insert and remove. This cable can be used with a board to easily connect sensors and drivers from one board to another. One end is equipped with JST-SH female 4-pin connector and the other end is equipped with DuPont male connector. These are 1 mm apart instead of 2mm, compared to the thicker jst-ph, but still have a good locking feel while being easy to insert and remove. This cable can be used with a board to easily connect sensors and drivers to a board with a 0.1" socket connector or a solderless breadboard. One end is equipped with a JST-SH female 4-pin connector, and the other end is equipped with a high-quality female connector. These are spaced 1 mm instead of 2 mm compared to the coarser JST-PH, but still provide a good locking sensation while being easy to insert and remove. This cable can be used with a board to easily connect sensors and drivers to the board via the usual 0.1" row pins. This cable turns the 3-pin cable port into 3 individual wires with a high quality 0.1" female socket at the end. For expanding and connecting sensors or leds - wires are even color coded! _x000D_ _x000D_