Item Type: Power Supply Module_x000D_ Electrical Parameters: _x000D_ 1. Input Voltage: DC5-32V, it is recommended to use voltage above 10V_x000D_ 2. Output Voltage: DC1V-30V continuously adjustable_x000D_ 3. Output Current: 10A (maximum) within 7A for a long time_x000D_ 4. Output Power: Long-term 80W, peak 130W, more than 80W, please strengthen heat dissipation_x000D_ 5. Output Ripple: 50mV (12V to 12V, measured at 5A)_x000D_ 6. Input Reverse Connection Protection: None, if necessary, please connect a Schottky diode in series with the input_x000D_ 7. Output Anti-Backflow: None, if used for battery charging or the load is a self-charged emotional load, please connect a Schottky diode in series with the output_x000D_ 8. Size: Approx. 77.6 x 46.5 x 15mm / 3.1 x 1.8 x 0.6in_x000D_ 9. Short Circuit Protection: Yes_x000D_ 10. Weighs: Approx. 45g / 1.6oz_x000D_ Debugging Method: _x000D_ 1. Adjustment Method of Battery Undervoltage Protection: (take 12V lead-acid battery to set 10V undervoltage protection, turn off the output as an example)_x000D_ Adjust the input connected regulated power supply to 10V, adjust the undervoltage protection potentiometer (increasing CW, decreasing CCW) until the fault indicator (red light) lights up, and the setting is successful; so when the battery is discharged to 10V, It will automatically cut off the power supply to protect the battery from damage._x000D_ Note: If it is not battery-powered, you can not set it;_x000D_ 2. The Output Voltage Adjustment Method: The input is connected to the power supply (the voltage is higher than the undervoltage protection value), the red light is off, the blue light is on, the output is connected to a multimeter, and the output voltage potentiometer is adjusted (CW increase, CCW decrease), Until the required voltage;_x000D_ Note: Normally, the red light is off, the blue light is on, otherwise it is faulty. Input undervoltage protection, output overcurrent protection, output short circuit protection, please remove the fault and power on again._x000D_ 3. Output Current Adjustment Method: (take 12V input to charge 12V lead-acid battery, charging current 5A as an example)_x000D_ The input is connected to a 12V power supply, and the output is connected to an ammeter (the red test lead is connected to the positive output, the black test lead is connected to the negative, and the output is directly shorted. It is recommended to use an ammeter above 15A to prevent burning), adjust the constant current potentiometer (CW increase, CCW decreases) until the ammeter shows the required value of 5A. Remove the ammeter and connect the battery to charge normally._x000D_ Note: If used for constant voltage equipment, only the maximum output current needs to be set.