Paintless Dent Repair Puller Kit - Dent Puller Slide Hammer T-Bar Tool with 16pcs Dent Removal Pulling Tabs for Car Auto Body Hail Damage Remover About items?SAVE TIME &COST: Dent repair kit can save a lot of money for you compared with the auto body shops, our paintless dent removal tools kit can help you repair your cars by yourself for many times. INSPIRED DESIGN : Our slide hammer T bar puller tool uses a lever-type design for metal panel dent repair works, and can also be decomposed into two different T bar, clever use. Widely used: The Slide Hammer T-Bar Tool is not only for car dent removal, but also can be used refrigerator, motorcycle body, washing machine and hail damage. Corresponding to different dents: The Slide Hammer Tool contains two kinds of plastic tabs, a total of 16pcs professional tabs can be repaired against a variety of dents, dent repair lifter can also be adjusted, according to the size of the dent can be adjusted. DURABLE: Tempered high carbon stainless steels and standard stainless steel are used depending on the design of a particular tool. rubber and durable plastic, they will don"""t hurt the auto surface, very sturdy and keep a long lifetime. Package Contents: 1* Car Dent Puller Tools 18* Blue Glue Tabs/ Lifter Glue Puller Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm. How to use: 1.Clean the dent with a clean wet cloth; 2.Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes; 3.Choice the proper drawing gasket, you have 16 sizes gasket, Large dent requires a large drawing gasket. 4.Pull the trigger and apply the drawing gasket with extruded glue. 5.Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 3-5 minutes. The cooling time should be less than 8 minutes and should be shorter slightly in winter); 6.While use this dent removel T Bar tools, pull the sliding rod backwards to pull up the dent; 7. Check with a Line board. If dent still exists, knock it slightly with a knockdown tool. 8.Use alcohol and plastic shovel to clean up the residual glue.