1、ABS Material: High temperature resistance, corrosion resistance, providing a safe and comfortable grip feeling. 2、Anti Slip: The surface of the premium handlebar is textured and anti slip, providing you with safe driving. 3、Fast Heating: 5 level thermostat allows you to precisely adjust the temperature and find the best temperature for driving. 4、High Low Temp Adjustment: Allow you to change the temp without removing your hands from the handle to achieve safer riding. 5、Universal Accessories: Extensively suitable for all motorcycles or ATVs with 22 mm 7/8 inches diameter handlebar. 2 x Motorcycle Heated Grip Item Type: Motorcycle Heated GripMaterial: ABSColour: BlackVoltage: 12VProcessing Temperature: 50-70℃Power: 15-35WApplication: For motorcycles or ATVs with 22 mm 7/8 inches diameter handlebar.How to Use: 1. Pour parts cleaning agent (not included) or lubricating oil (not included) into the middle of the grip cover and the handle and shake it back and forth on the grip cover, then you can pull out the grip cover and save it for future use. If you no longer need it, you can Use a knife (not included) to cut and remove the handle cover. Please follow the respective removal methods for metal handles. 2. Please pull out the throttle cable from the throttle core before replacing the throttle core in the accessories. If the cable is too hard or pulled hard, it will cause danger. Be sure to pull the cable loosely before pulling it out. 3. The cable inside the throttle core is loosened a bit. If the throttle core is replaced, please adjust the tightness of the throttle cable to a proper tightness. When adjusting, make sure that the throttle valve can operate smoothly. 4. Apply adhesive (not included) on the handle. If it is too thick, it may ooze and cause stains. Please use thick cardboard (not included) or scraper (not included) to spread the adhesive thinly, and then insert the handle cover. There is a hexagonal screw on the controller side. Be sure to loosen the screw before inserting it, and then tighten it last. 5. After the power is turned on, the indicator light flashes three times and enters the standby mode (green light flashes‑normal, red light flashes less than the operating voltage). The heater has five temperature adjustments. Through the switch control, the light changes from blue to red, and the output will gradually increase at a rate of 20% each time. If the light flashes or goes out, it means that the voltage has dropped and you need to replace the battery (not included) or replace the line. Wiring instruction: red wire to the positive, black wire to the negative.