1、The thermostat is digitally displayed, with a high-brightness digital tube display, and it can be read clearly in the dark.<br> 2、Using super thick ABS material shell, with high mechanical strength, good electrical performance and not easy to age.<br> 3、The thermostat has an ultra‑wide temperature control range and high accuracy, which is suitable for temperature control in different fields.<br> 4、Use stainless steel high‑quality probe, resin sealing treatment, which is waterproof and rust‑proof.<br> 5、Easy to operate, only need to wire to connect, over‑configuration to meet the needs of various industrial control equipment.<br> 1 x Temperature Controller<br> Item Type: Temperature ControllerMaterial: ABSTemperature Measuring Probe: NTC10KSensor Wire Length: Approx. 2m /<br> 6.6ftTemperature Measurement Range: -50~110℃Temperature Measurement Accuracy: ±<br> 0.1℃Output Current: ≤10ASupport Power: ≤2000WSize: Approx. 147 x 96 x 45mm /<br> 5.8 x<br> 3.8 x<br> 1.8inUses: Widely used in the field of incubation, equipment chassis, air conditioning systems, temperature control protection and other fieldsHow to Use:<br> 1. Set the Temperature Calibration: If The Real-time Measured Temperature Is Different From The Actual temperature, press this key to adjust; method: Long press the calibration key to display ADJ and flashing words, press the up and down keys to adjust, then press the enter key to save and exit<br> 2. Set the Stop and Start Temperature: Press the set button once, the stop temperature flashes, press the up and down keys to adjust; press the set button again, the start temperature flashes, press the up and down keys to adjust, press the enter key to save<br> 3. Restore Factory Settings: After power-on, press the up and down keys at the same time for more than 3 seconds, after displaying 888, the recovery is successful; when LLL is displayed, it means that the temperature sensor is not plugged in, disconnected, or damaged, just replace it; when HHH is displayed, it means it exceeds 110 ℃ measuring range, or the sensor is short-circuited, the sensor needs to be replaced